Table of Contents
Advertisement
Set required time as follows:
— work
— Each time the key is pressed, the values changes by 1. by
keeping the key pressed down, the value changes faster.
— confirm using
The symbol
stops flashing.
•
Switch-off
— press
several times until all hourly programming de-
tails are no longer displayed
9
Set time is saved by the remote control and is displayed any
time user presses
9
Programming remains active even when remote control is
off.
9
Hourly programming has higher priority over the Night func-
tion. If Automatic switch-off is active, the unit turns off even
though the Night function is still active.
Selecting the temperature measurement unit
If required, it is possible to change the temperature measure-
ment unit.
The available units are:
— Celsius °C
— Fahrenheit °F
Select required unit as follows:
— work
— Each press will select a different unit, toggling between °C
and °F .
Setting the transmission code
If two indoor units are installed close to one another and user
wishes to control them separately, two different transmission
channels can be set.
For communication to succeed, the selected communication
channel on indoor unit and remote control must be the same.
Available transmission channels are:
.
Factory set channel is A.
Select required channel as follows:
— work
Each press will select a different channel, toggling between A
and b.
9
The unit will not operate if the transmission channel settings
in indoor unit and remote control are not the same.
9
To change transmission channel on indoor unit, contact the
Technical Support Service.
Button locking
Prevent any accidental control by locking remote control but-
tons.
•
button locking
— at the same time, press
Remote control display shows
•
button unlocking
— at the same time, press
Remote control display no longer shows
2.5
Emergency switch
The emergency switch allows equipment switch-on and off in
an emergency (faulty remote control, flat batteries).
Switch-on occurs with preset settings according to detected
ambient temperature:
Ambient temperature above 24 °C
— Cooling mode
— Temperature setting 24 °C
— Ventilation speed Auto
— Hourly programming off
Ambient temperature below 24 °C
— Heating Mode
— Temperature setting 24 °C
— Ventilation speed Auto
— Hourly programming off
9
Presets cannot be changed.
17
USE
+
.
+
.
Advertisement
Table of Contents
