USE
Remote control display shows
off.
9
The equipment will operate at selected ventilation speed.
9
The equipment will operate to keep room temperature at
10 °C.
•
Switch-off
— press
Remote control display no longer shows
value will be indicated.
Switching unit display off or on
If required, indoor unit display can be turned off or on.
AMW P
1
1
Display
AMW ST
1
Display
— work
Each pressure turns display off or on.
Hourly programming
Hourly programming allows user to set equipment on and off
times.
Switch-on occurs in the current operating mode.
Automatic switch-on
Automatic switch-on programming allows user to set equip-
ment ON time.
9
before activation, set current time.
and temperature value will go
and temperature
1
•
Activation
— aim the remote control on the side opposite to unit re-
ceiver
— press
The remote control turns on.
— aim the remote control to unit receiver
— press
Remote control display shows
time.
Set required time as follows:
— work
Each time the key is pressed, the values changes by 1. by keeping
the key pressed down, the value changes faster.
— confirm using
The symbol
stops flashing.
•
Switch-off
— press
several times until all hourly programming de-
tails are no longer displayed
9
Set time is saved by the remote control and is displayed any
time user presses
9
Programming remains active even when remote control is
off.
Automatic switch-off
Automatic switch-off programming allows user to set equip-
ment OFF time.
9
before activation, set current time.
•
Activation
— press
several times until
Remote control display shows previously set time.
16
TIMER
blinking and previously set
.
TIMER
is displayed as blinking