Unit For Temperature Display - Dometic COOLAIR RTX1000 Installation Manual

Configuring the system software
✓ The display shows "P.01" and the symbol
➤ Press the
✓ The current setting is displayed.
➤ Use the
down.
The low voltage shut-down setting can be adjusted in 0.1 V increments:
– RTX 24 V: from 20.0 V to 23.5 V
– RTX 12 V: from 10.0 V to 11.7 V
I
NOTE
The level for the low voltage shut-down should not be set any lower than the
minimum battery voltage required to be able to start the engine under any
conditions.
As a rule that should be no less than 22 V (RTX 24 V)/11 V (RTX 12 V).
➤ Press the
✓ The set value is saved and is then applied when the system is restarted.
✓ You are then returned to the menu and can select another menu item by
pressing the
8.3 P.02: Unit for temperature display
The system can display the room temperature in °C or °F. This parameter can be
configured:
➤ Switch to configuration mode (chapter "Entering and exiting configuration
mode" on page 13).
✓ The display shows "P.01" and the symbol
➤ Press the
✓ The display shows "P.02" and the symbol lights up.
➤ Press the
✓ The code for the current setting is displayed:
– 0: °C
– 1: °F
➤ Use the
➤ Press the
✓ The set value is saved and is then applied when the system is restarted.
✓ You are then returned to the menu and can select another menu item by
pressing the
14
button to change the setting.
or button to select the voltage level for low voltage shut-
button to save the setting.
or button.
or button to select the menu item P.02.
button to change the setting.
or button to select the desired temperature unit.
button to save the setting.
or button.
CoolAir RTX1000, RTX2000
flashes.
flashes.
EN