Fixing The Cover Frame - Dometic COOLAIR RTX1000 Installation Manual

Installation
➤ Connect the positive lead (red) for the power supply via a fuse:
– RTX 24 V: 40 A
– RTX 12 V: 80 A
➤ Connect the positive lead (red) for the voltage monitor via a 2 A fuse.
➤ Connect the wiring loom to the unit and fix with a cable tie in a suitable
position (fig. a 2.).
RTX 12 V
I
NOTE
Place the fuse holder no more than 0.3 m from the positive terminal of the
battery.
➤ Attach the fuse holder in a suitable location.
➤ Lay the positive cable (red) to the fuse holder and trim.
➤ Trim the shorter connection cable from the fuse holder to the correct length
and connect with a joint connector on the positive cable (red).
➤ Insulate the connection cable with the joint connectors properly.
➤ Trim the longer connection cable from the fuse holder if necessary and fit a
suitable ring terminal.
➤ Connect the longer connection cable from the fuse holder with the ring
terminal directly to the positive terminal of the battery.
7.8

Fixing the cover frame

The outlet unit should be flush with the cover frame when installed (fig. b).
➤ Trim the cover frame to fit the vehicle.
A
NOTICE!
Tighten the screws carefully in order not to damage the cover frame.
➤ Fix the cover frame in place as illustrated (fig. b).
12
CoolAir RTX1000, RTX2000
EN