Advertisement
Figure 1
1. To instal the device you have to dismantle carefully the
device with a flat screwdriver as shown on figure 1.
2. Pass the mains cables through the hole
(point 1 on figure 2). The luminaire must be connected to
a permanent electrical installation to ensure the
immobilization of the cable.
3. Mount the base plastic on the wall by using the included
mounting accessories in points 2 and 3 on figure 2.
4. Connect the battery`s cable with the appropriate terminal
(figure 3).
5.
Connect the mains cables to the respective detachable
terminal block. Ν for neutral, L for live wire and L1 for the
maintained operation. The L1 wire can be connected to an
external switch to control the maintained or non maintained
operation of the luminaire. For permanent maintained
operation use two wires to power the luminaire, Ν for neutral
and L for live wire, and link the L and L1.
6. Refit with care the removed plastic parts and power on
the luminaire.
NOTE!!
After finishing the installation you must power the luminaire at least for 24 hours for
battery charging to perform the nominal autonomy.
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
Page 3 from 4
INSTALLATION INSTRUCTIONS
1
3
LED MODULE CHARACTERISTICS
GR-2100/ST
Non reversible connection between main pcb and led module
2
Figure 2
Olympia Electronics S.A
3105165
8.7-10.8VDC
780mW
45 °C max. across the board
Figure 3
N
L
External
switch
Controled operation
of the illumination source
N
L
Link
Permanent
operation of the illumination source
GR-2110/ST
923211004_09_004
Advertisement
