Advertisement
supply and the battery should be connected
and fully charged. If the battery is not fully
charged, the test is postponed until the
battery is completely charged. If during this
test, the autonomy is less than nominal then
the battery fault led turned on continuously
and the battery must be replaced.
Back Up Operation
The autonomous duration of battery during
emergency mode is at least 180 minutes.
During emergency mode, a light source test
is also performed.
Resetting Errors
Push the Test button for more than 5
seconds, to delete all the indicated LED
errors. Then
the device enters regular
operation mode.
Indication LED status (with connected
mains power supply).
Charge (Green LED)
On: Good charge condition.
Οff: No battery (No charging current
or disconnected battery).
Fault (Red LED)
Οn : Faulty LED strip (must be replaced) or
emergency circuit (must be checked by an
authorized personnel).
Blink (With Charge LED ON): Autonomy or
low battery problem (the battery must be
replaced).
Οff: LED strip and battery ok.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance
or testing must be done by authorized
personnel only.
2. The device must be connected to the
m a i n s p o w e r s u p p l y t h r o u g h a f u s e
dependent by the total amount of the line's
power load.
3. In case of inactive use for a period greater
than 2 months, disconnect the battery by
The light source contained in this luminaire shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
Page 2 from 4
pulling out the battery's connector.
4. I s not allowed to discard batteries in to
t i
common trash bins, they must be
discarded only
points. Do not incinerate.
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained (*)
A: Including test device
G: Internally illuminated
90: 1.5 hour duration
180: 3 hours duration
NOTE!! The installer should fill in, on the
specification label, the letter G if the luminaire is
used as a safety sign.
X 1
(*) Maintained operation: The luminaire lights
its illumination source, when it is powered by
the mains power supply or not.
Non Maintained operation: The luminaire
lights its illumination source, only in power
supply's failure.
Battery replacement.
It can be done only by a competent person
and after the mains interruption.
1. Dismantle the device (step 1 of the
installation instructions).
2. Disconnect the connector and remove the
old battery.
3. Connect the new battery with the same
type (step 4 of the installation instructions)
and place it in the position of the old one.
4. Follow the step 6 of the installation
procedure and power the device.
in battery recycling
A
9 0
G
923211004_09_004
Advertisement
