Advertisement
installation instructions
range hood
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT –
Save these instructions for local inspector's
use.
• IMPORTANT –
Observe all governing codes and ordinances.
• Note to Installer - Be sure to leave these instructions with the
Consumer.
• Note to Consumer – Keep these instructions for future reference.
• Skill level – Installation of this appliance requires basic mechanical
and electrical skills.
• Completion time – 30 minutes–3 hours.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under
the Warranty.
FOR YOUR SAFETY:
WARNING –
Before beginning the installation, switch power
off at service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When the
service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
DUCTWORK REQUIREMENTS
NOTE: Read the ductwork sections only if you do not have existing
ductwork. If you have existing ductwork, skip to the "Damage" sec-
tion and proceed.
WARNING –
TO REDUCE THE RISK OF FIRE AND TO PROP-
ERLY EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE—DO
NOT VENT EXHAUST AIR INTO SPACES WITHIN WALLS OR
CEILINGS OR INTO ATTICS, CRAWL SPACES OR GARAGES.
The venting system must exhaust to the outside.
This hood can be vented vertically through upper cabinets or hori-
zontally through an outside wall. Ductwork is not included.
Exhaust connection:
The hood exhaust has been designed to mate with standard 3 1/4" x
10" rectangular ducting or 7" diameter round ducting.
If a 6" round duct is required, a rectangular-to-round transition
adaptor must be used*. Do not use less than a 6" diameter duct.
9
Advertisement
