Advertisement
20
C. Outside rear exhaust
(Horizontal duct 3 1/4" x 10" Rectangular)
Use the diagram or the hood as a template and mark the loca-
tions on the cabinet for ductwork and keyhole screw slots.
Wood shims
(recessed-bottom cabinets only-shims must be
a minimum of 3/8” thick and cut to fit the width
of the inner recessed cabinet bottom).
Hood mounting screws (4)
D. Recirculating
• Use the hood as a template and mark the locations on the
cabinet for ductwork and keyhole screw slots.
• Since the hood is to be recirculated (not to be vented out-
side), do not cut out any vent openings in the wall or cabinet
bottom.
10
CUT HOLES
Cut holes at marked locations for duct. For the vertical duct,
cut out 3/4" extra toward the front of the cabinet so you can
move the duct freely when installing the hood. It may also ease
installation by cutting the hole 10 1/2" instead of 10".
11
SCREW IN PART WAY
Drive a mounting screw (from the hardware packet) part way
into each center of the narrow neck of the keyhole slots
marked on the cabinet bottom.
Cabinet front
Horizontal duct
9,5 cm
access hole
Parte inferior
del gabinete
5¼”
10¾” (24” hood)
13¾” (30” hood)
16¾” (36” hood)
Center line
1/2”
5¼”
10¾” (24” hood)
13¾” (30” hood)
16¾” (36” hood)
Advertisement
