Advertisement
5
REMOVE DUCT KNOCKOUT
If recirculating, non-vented ductless skip to Step 9 D and
proceed.
Using a flat-blade screwdriver, remove the appropriate duct
knockout from the top or back of the hood.
3¼” x 10” Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
6
FOR 3-1-4" X 10" RECTANGULAR DUCTED DIS-
CHARGE INSTALLATIONS ONLY:
Attach exhaust adaptor/damper over the appropriate knock-
out opening (for vertical or horizontal, depending on installa-
tion) with two exhaust adaptor screws. Make sure damper
pivot is nearest to top/back edge of hood. Remove tape from
damper flap.
Pivot
(depending on
installation)
7” Round vertical discharge.
Remove circular duct
knockout only
3¼” x 10” Rectangular horizontal discharge.
Remove rear rectangular duct knockout only
Exhaust adaptor/damper
(vertical discharge position)
Top/back edge
Exhaust adaptor/damper
(horizontal discharge position)
Tape
17
Advertisement
