Troubleshooting - Klarstein Eiszeit Manual

EN
20

TROUBLESHOOTING

• Please note, if a power failure occurs due to disconnection of the power cord, or
the off power button has been pushed off during an ice making cycle, small ice
chips may formed and lodge in the automatic shovel causing it to jam. If this occurs,
the ice chips may be removed by disconnecting the power cord and gently pushing
the shovel to the rear of the cabinet and removing the ice chips, then restarting.
• Please restart the ice maker by pressing Stop and then Start. If the Ice shovel does
not push the Ice into the Ice collector after the formed Ice drops from the evaporator
finger while at the same time the M light is on, check to see if the water tray is
horizontal or balanced. If not then adjust by pressing the Ice shovel lightly with your
finger. Then re-start the Ice maker.
Problem
The compressor works
abnormally with a Buzzing
noise.
Water shortage indicator
light is on.
Possible Cause
The voltage is lower than
recommended.
There is no water
The pump is full of air
Suggested Solution
Stop the Ice maker and do
not restart until the voltage
is normal.
Fill with water, wait 3
minutes and press the
"ON/OFF' button to
restart.
Open the drain cap, and
let several drops water
runs out.