Troubleshooting - Klarstein ON-THE-ROCKS Manual

EN
22

TROUBLESHOOTING

Please note, if a power failure occurs due to disconnection of the power cord, or the
power button has been pushed off during an ice making cycle, small ice chips may
formed and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips
may be removed by disconnecting the power cord and gently pushing the shovel to the
rear of the cabinet and removing the ice chips, then restarting.
Please check if the water reservoir is flat when the ice shovel can not remove the ice to
ice basket. If not, please push the ice shovel gently by finger, then press POWER button
to restart.
Problem
The compressor works
abnormally with a Buzzing
Noise.
Water shortage indicator
light is on.
Indicator lights on display
are not on.
The Ice made is too large
and with pieces sticking
together.
All indicators twinkle
simultaneously.
Possible Cause
The voltage is lower than
recommended.
There is no water.
The pump is full of air.
Blown fuse/ No power.
Water temperature is too
low.
.Ice of previous cycles left
in the water tray.
Water tray is blocked by
ice cube.
Suggested Solutions
Stop the Ice maker and do
not restart until the voltage
is normal.
Add to some water until it
reaches MAX position.
Press POWER button to
restart.
Replace fuse / Turn power
on.
Select small size.
Take out the ice under the
standby state.
Unplug the power to
take out the ice which
blocking the tray, then
plug the power and press
the POWER button, the
machine will restart 3mins
later.