Mounting On Flush-Mounted Boxes - HomeMatic HmIP-WRCR Mounting Instruction And Operating Manual

• Drill the marked holes (see figure 8).
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws
easier to insert.
• Use the supplied screws and plugs to fasten the
mounting plate to the wall (see figure 9).
Place the clip-on frame (A) onto the plate (D) (see
•
figure 10).
Insert the electronic unit (B) into the clip-on
•
frame (see figure 10). Make sure that "TOP" and
the arrows on the back side of the electronic unit
point upwards and that the clips on the mounting
plate latch into the openings on the electronic
unit.
5.2.3

Mounting on flush-mounted boxes

You can mount the device on flush-mounting/installation
boxes using the screw holes (see figure 11).
If the device is mounted to a flush-mounting box,
there may be no open conductor ends.
Start-up
41