John Shearer Pasture Renovation Drill Operator's Manual page 58

MENU key until the input the sensor used for calculating rate information is connected to is
1. Press the
displayed (input 1 – 6).
Press ENTER to edit the input function and use the NAV keys to select the SPEED option as shown in
2.
Figure 13 below.
Select SPEED setting with desired Units.
3.
• DO NOT MIX METRIC AND IMPERIAL UNITS.
Clear PULSES by holding CLEAR for approximately 1 second.
4.
Ensure Jackal is in RUN mode (when in HOLD mode "ON HOLD" is displayed at the top of the screen)
5.
Drive a known distance. Jackal should count pulses.
6.
Enter distance into monitor using NAV keys and hold SET for approximately 1 second to calculate
7.
WHEEL factor.
Enter the Implement WIDTH using the NAV keys.
8.
Note: These steps refer to SET and CLEAR buttons. They are activated by the softkeys which will
have the words on the screen above the button (as shown in figure 13 above), when in the correct
OPTIONAL JACKAL (P/N: 42978) CALIBRATION
For more information refer to the Farmscan Jackal manual.
Figure 13.
menu.