John Shearer Pasture Renovation Drill Operator's Manual page 26

Current Bin 1
Speed settings and
Hectares
travelled
Step 3) Press "Pause" of "Finish" to stop seeding. If you press pause, you
can re-start from where you left off.
Note1)
If the incorrect sprocket ratio has been selected for the product, or you are
driving too fast (or too slow – for a low speed warning), you may see a
warning like this below:
Bin 2
settings and
"On-the-go" Seed
rate adjustment (Up,
Finish and
Down & Pause)
Pause
buttons. Rate can be
buttons
adjusted in 1 kg/ha
increments.
This means that the limits of the motor/s have been exceeded. The
solutions could be to either drive slower (or faster for a low speed warning)
or to calibrate with a more acceptable sprocket ratio for the selected rate.
The chart on the following page will guide you to an appropriate sprocket
ratio.
If seeding continues with this warning, the rate accuracy will be affected.
Note 2)
On machines with bin level sensors, "empty" will show up when a bin is
very low or empty. This means it is time to stop and top up the bin.
18
02.19M143J1
High
speed
warning