After Vacuuming - Dirt Devil Trendino Operating Manual

4 After vacuuming

3.4 Use as a brush vacuum
cleaner
1. Carry out steps 1-4 under
as a stick vac' .
2. Switch the electric cleaning brush on by
putting the 2-stage switch into "brush vac-
uuming" position (Fig. 3).
WARNING:
When you operate the appliance in "brush
vacuuming" mode (Fig. 3), the brushing
roller rotates with a high speed. The brush-
ing roller must not be touched while operat-
ing as otherwise there is a risk of injury.
3. To vacuum, push the vacuum cleaner
back and forth. When vacuuming, observe
the corresponding recommendations of
the flooring manufacturer.
3.5 Use as a hand vac
1. Hold the hand vac firmly by its handle and
press the release button (Fig. 4/1) to un-
lock the hand vac.
2. Pull the hand vac forwards out of its brack-
et.
3. Insert the plug into a plug socket.
ATTENTION:
Only operate the appliance if the electrical
voltage stated on the type plate matches the
voltage of your socket. Wrong voltage can
destroy the appliance.
4. Switch the appliance on by putting the 2-
stage switch (Fig. 1/4) into the centre.
The crevice nozzle (Fig. 1/15) is con-
tained in the bracket as an accessory. Attach
the crevice nozzle as follows:
1. Remove the crevice nozzle from its holder
in the bracket (Fig. 5).
2. Insert the crevice nozzle (Fig. 6/1) into the
suction end of the hand vac (Fig. 6/2).
18
4
Page 17, 'Use
4.1 Switching off
1. Switch the vacuum cleaner off using the 2-
2. Pull the plug out of the plug socket.
4.2 Transporting
1. If you have used it, stow away the crevice
2. If you have used it, stow away the hand
3. If necessary, lower the telescopic stick
4. Wind the electric cable around the cable
5. Put the floor nozzle into transport position
You can now transport the vacuum cleaner
both by using the handle (Fig. 1/11) and using
the hand vac handle (Fig. 1/3).
4.3 Storage
longer period of time, empty the dust contain-
er and clean it
container'. Keep the appliance in a cool, dry
room.
After vacuuming
WARNING:
When you leave the work area, switch the
appliance off and pull the electric cable out
of the plug socket by holding the plug. Oth-
erwise, there is a risk of injury.
stage switch (Fig. 1/4).
nozzle by pushing it forcefully back into its
mount. It will click into place audibly.
vac back in its bracket. It clicks audibly in-
to place.
(Fig. 2/B) until it clicks into place.
mount (Fig. 1/8).
by aligning the vacuum cleaner exactly
vertical to the floor. The floor nozzle clicks
noticeably into place.
ATTENTION:
Never position the appliance directly against
heat sources (e. g. heating, oven). Avoid
direct sunlight. Heat can damage the appli-
ance.
If you want to store the appliance for a
Page 19, 'Emptying the dust