Operating; Vacuuming - Dirt Devil Bag Line 7050 Operating Manual

3 Operating

1 1
Fig. 9

3.1 Vacuuming

3 Operating
WARNING:
Only assemble the nozzles if the plug has been removed
from the socket. The appliance could be switched on by
accident.
Proceed as follows to attach the nozzles:
1. Switch the appliance off and pull the plug out of the
socket.
2. Remove the existing nozzle from the telescopic tube.
3. Push the desired nozzle onto the lower end of the tele-
scopic tube or if necessary directly onto the handle
(Fig. 9).
ATTENTION:
If you use the cylinder vacuum cleaner without an
attached nozzle, there is a greater risk of accidentally
vacuuming up objects.
4. Secure the nozzles no longer required in the accesso-
ries mount, as far as this is possible. Keep the other
nozzles safe and inaccessible to children.
.
WARNING:
Check the cylinder vacuum cleaner and the power cable
before each use. A damaged appliance must never be
used. There is a risk of injury.
WARNING:
Especially when cleaning stairs take care that you
always stand above the appliance.
ATTENTION:
Only use the cylinder vacuum cleaner if all the filters are
intact, dry and inserted correctly. Make sure that none of
the openings are blocked. Otherwise, the vacuum
cleaner can become damaged.
NOTE:
Your cylinder vacuum cleaner has an overheating protec-
tion device. It turns off automatically if it overheats. If this
happens, then turn off the cylinder vacuum cleaner and
remove the plug. Remove the cause of overheating. Wait
approx. 45 minutes. Once the cylinder vacuum cleaner
has cooled down you can switch it on again.
27