PowerBox Systems LightBox SR Instruction Manual page 6

With these standard settings, a single conventional servo output at the receiver
and a three-position switch operate the unit as follows: the first position switches
2x flashing light and 1x beacon; at the second position an additional landing light
can be activated.
The low-voltage cut-off threshold for the lighting system is set at 2.5 V; the unit
switches itself off at this point.
3. SETTING THE LED FUNCTIONS USING THE PC
If you wish to assign other functions to the outputs, or activate the serial input, you
will need to use the PowerBox Terminal program, which can be downloaded from
our website:
http://www.powerbox-systems.com/downloads/powerbox-terminal.html
The program is free, and can be used to update the LightBox SR as well as ad-
just its settings. Instructions for installing the program can also be found in the
Download area. Once you have installed the program, connect the USB Interface
Adapter (Order No. 9020) to the PC. Other makes of USB adapter, such as those
made by Jeti or Multiplex, can also be used.
Connect the UNI plug on the adapter lead to the USB input on the LightBox SR. If
you have not yet installed the LightBox SR in a model, the power supply can take
the form of any battery in the range 4 V – 9 V. Plug the battery into the socket
marked Receiver.
Don't start the Terminal program on your PC until have completed these steps.
PowerBox-Systems − World Leaders in RC Power Supply Systems
6