Settings - Atag VA63211LT User Manual

Consumption values
1)
Programme
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the values.
Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com

SETTINGS

Programme selection mode and
user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener according
to the water hardness.
• The activation or the deactivation of the
acoustic signal for end of programme.
• The deactivation of the rinse aid
dispenser when you want to use the
Multitab option without rinse aid.
• The level of rinse aid according to the
required dosage.
These settings will be saved until you
change them again.
Water
(l)
10.2
7 - 14
12.5 - 14.5
10
4
Write down the product number (PNC) that
is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when only the indicator of the
programme
When you activate the appliance, usually it
is in programme selection mode. However,
if this does not happen, you can set the
programme selection mode in the following
way:
Press and hold simultaneously
and
selection mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness is
measured in equivalent scales.
Energy
(kWh)
0.932
0.6 - 1.4
1.4 - 1.6
0.9
0.1
is on.
until the appliance is in programme
7
Duration
(min)
225
40 - 150
154 - 164
30
14