Advertisement
Turn breaker On
10. Leaving thermistors unplugged, turn breaker back to on position.
Run water
11. Run hot water tap at sink for approximately 2/3 mins. Within this time, the unit should begin
to heat water.
12. Make sure LED light is illuminated on heater. If not, Make sure the correct breaker was turned
on.
Issue resolved.
If the heater begins to heat with thermistors disconnected, then these parts need to be replaced. If
the heater is still within warranty, part will be covered. If not, parts can be purchased online at
Amazon.com or through our support team see links below.
a. If the heater begins to heat with thermistors disconnected, then these parts need to be
replaced. If the heater is still within warranty, parts will be covered. If not, parts can be
purchased online at Amazon.com or through our support team.
i.
https://www.amazon.com/EcoSmart-THRM-Ecosmart-
Thermistor/dp/B00Z0Z5IP2/ref=sr_1_1?s=industrial&ie=UTF8&qid=1518718177&sr=1-
1&keywords=Ecosmart+thermistor
ii. Support info email at
b. Issues not resolved
i. Please go to Activity C | Electrical Connection
| © 2018 All rights reserved. | EcoSmart™ | www.ecosmartus.com |
support@ecosmartus.com
or by phone at 877-474-6473
Page | 5
Advertisement
