Advertisement
E 3 Error Code | Outlet & Inlet Thermistors
If you unit is displaying an E3 error code. Your unit is notifying you the outlet & inlet
thermistor is not reading correct Temperature and may need to be replaced. In order
to temporary resolve this issue please follow the below steps. Keep in mind, this is
only a short term fix. You will still be responsible for replacing you inlet thermistor.
Bypassing E1 Error Code
Turn on water so LED display is on and reading E3 error
1.
Hold down round knob for 3/5 seconds and release.
2.
At this point your LED display should be reading CE3
3.
Keep water running for 2/3 mins and check for hot water.
4.
This work around will allow you to receive hot water while waiting for the
replacement part. While your unit is running in the CE3 mode, the heat will default to
125 degrees as a normal tank heater would. In this mode you will not be able to
control your outlet temperature. Keep in mind you may need to mix some cold water
in order to reach the desired Temperature.
If the heater is still within warranty, part will be covered. If not, parts can be
purchased online at Amazon.com or through our support team see links
below.
o
https://www.amazon.com/Ecosmart-HE-90240-Heating-
Element/dp/B00Z0Z5J4M/ref=pd_sim_60_1?_encoding=UTF8&pd_rd_i=B00Z0Z5J
4M&pd_rd_r=7XV5X49JRPG6XGFVWCPQ&pd_rd_w=9PcS8&pd_rd_wg=toK58&psc
=1&refRID=7XV5X49JRPG6XGFVWCPQ
o Support info: 877-474-6473 or
| © 2018 All rights reserved. | EcoSmart™ | www.ecosmartus.com |
Support@ecosmartus.com
Page | 20
Advertisement
