1. Locate plastic housing covering the LED control board. See below images for help.
a. Make sure breaks are turned off.
b. Remover round knob
c. Locate 4 philips head screws, 1 in each corner of housing and remove.
d. Locate fuse on upper right hand corner of board.
e. Insert new fuse (250V-200-400 mA)
f. Turn on breakers and verify if unit is turning on.
| © 2018 All rights reserved. | EcoSmart™ | www.ecosmartus.com |
Fuse B/250 volte 500 milliamps Fast Acting
Page | 11