Advertisement
Activity D |Checking Fuse
Each heater is equipped with one inline fuse. This fuse is designed to protect the control board
against power surges. Depending on your model, your heater will have one of two fuses. Follow
below steps to locate and test the fuse.
1. Locate plastic housing covering the LED control board. See below images for help.
a. Make sure breaks are turned off.
b. Remover round knob
c. Locate 4 philips head screws, 1 in each corner of housing and remove.
d. Locate round black fuse holder on top of housing and open.
e. Insert new fuse (250V 3 Amp)and put holder back together
f. Turn on breakers and verify if unit is turning on.
| © 2018 All rights reserved. | EcoSmart™ | www.ecosmartus.com |
Fuse A /250 Volt 3 AMP
Page | 10
Advertisement
