Maintenance - Husqvarna 325iLK Operator's Manual

Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance

Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
Make sure that the screws and nuts are tight.
Make sure that the battery release buttons on the battery works and locks the
battery in the product.
Make sure that the battery is not damaged.
Make sure that the battery is charged.
Make sure that the battery charger is not damaged and operates correctly.
Examine all cables, couplings and connections. Make sure they are not dam-
aged and free from dirt.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
Two piece-shaft
Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.
1386 - 002 - 04.12.2019
Maintenance
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
WARNING: Remove the battery before you
do maintenance.
Daily Weekly
X
X
X
X
X
X
X
X
X
X
Monthly
X
X
13