Husqvarna 325HS75 Operator's Manual
  1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Trimmer
  5. 325HS75 X-series
  6. Operator's manual
Husqvarna 325HS75 Operator's Manual

Husqvarna 325HS75 Operator's Manual

Husqvarna electric hedge trimmer operator's manual 325hs75, 325hs99
Hide thumbs Also See for 325HS75:
Table of Contents

Advertisement

Quick Links

See also: Operator's Manual
325HS75/HS99
Operator's Manual
Please read these instructions carefully and make sure
you understand them before using the hedge trimmer.
101 90 46-26

Advertisement

Table of Contents
loading

Related Manuals for Husqvarna 325HS75

Summary of Contents for Husqvarna 325HS75

  • Page 1 325HS75/HS99 Operator's Manual Please read these instructions carefully and make sure you understand them before using the hedge trimmer. 101 90 46-26...

  • Page 2: Symbol Explanation

    SYMBOL EXPLANATION Symbols WARNING! The hedge trimmer can be dangerous! Careless or incorrect use can result in serious, even fatal injury. Read through the Operator‘s Manual carefully and understand the content before using the hedge trimmer. Always use • Ear protection •...

  • Page 3: Table Of Contents

    Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. WARNING! Under no circumstances may the design of the machine be modified without the permission of the manufacturer. Always use genuine accessories.

  • Page 4: Safety Instructions

    SAFETY INSTRUCTIONS Personal protective eqipment IMPORTANT INFORMATION • Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand this manual.
  • Page 5 SAFETY INSTRUCTIONS 4. Vibration damping system The hedge trimmer is equipped with a vibration damping system, which is designed to give as vibra- tion-free and comfortable use as possible. The hedge trimmer’s vibration damping system reduces the transfer of vibrations between the engine/unit blades and the hedge trimmer’s handles.

  • Page 6: Control, Maintenance And Service Of The Hedge Trimmer's Protective Equipment

    Control, maintenance and service of the hedge trimmer’s protective equipment IMPORTANT INFORMATION • All service and repairs to the machine require special training. • This applies especially to the machine‘s safety equipment. If the machine does not meet any of he controls listed below you should contact your service workshop.
  • Page 7 SAFETY INSTRUCTIONS 5. Muffler • Never use a machine that has a defective muffler. • Check regularly that the muffler is secure. • If your muffler is fitted with a spark arrest screen then it should be cleaned regularly. A blocked screen leads to the engine overheating with serious damage as a result.

  • Page 8: General Safety Instructions

    • When storing the machine for long periods the fuel tank must be emptied. Contact your local petrol station to find out how to dispose of excess fuel. • The blades transport guard should always be fitted when transporting or storing the hedge trimmer. Min. 3 m (10 ft) WARNING! Exercise great care when handling fuel.

  • Page 9: General Working Instructions For Hedge Trimmer

    • Make sure that there are no foreign objects, such as electricity cables, etc., in your working area. Also remove any objects that could damage the hedge trimmer, such as metal items. • If any object is hit or if vibrations occur stop the machine immediately.

  • Page 10: Basic Working Techniques

    • When trimming a hedge the engine should always be turned away from the hedge. • The hedge trimmer should be held as close to the body as possible to get the best balance. • Make sure that the tip does not touch the ground.

  • Page 11: What Is What

    What is what on the hedge trimmer? Operator’s Manual Grease nipple Gearbox Blades Hand guard Handle Cylinder cover Starter handle Fuel cap Fuel tank Air purge Choke Throttle trigger lock Throttle trigger Stop switch WHAT IS WHAT? Air filter cover...

  • Page 12: Fuel Handling

    HUSQVARNA’s small, two-stroke engines. Mixing ratio 1:50 (2%). • If HUSQVARNA two-stroke oil is not available you can use a high quality two-stroke oil intended for air cooled engines. Contact your dealer when selecting an oil. Mixing ratio: 1:33 (3%).

  • Page 13: Start And Stop

    Always move the hedge trimmer about 3 metres from the filling position before the machine is started. Place the machine on a hard surface. Bear in mind that the blades could start to move when the engine starts.

  • Page 14: Maintenance

    Carburettor Your Husqvarna product has been designed and manufac- tured to specifications that reduce harmful emissions. After your unit has been run 8-10 tanks of fuel the engine has broken in. To ensure that your unit is at peak perform-...
  • Page 15 Adjusting the idle speed, T Adjust the idling speed with the screw T, if it is necessary to readjust. First turn the idle speed adjusting screw T clockwise until the blades start moving. Then turn the screw anti-clockwise until the blades stop. The idle speed is correctly adjusted when the engine runs smoothly in every position.

  • Page 16: Muffler

    Muffler NOTE! Some mufflers are fitted with catalytic converters. See “Techni- cal data” to find out if your machine is equipped with a catalytic converter. The muffler is designed to dampen the noise level and to direct the exhaust fumes away from the user.

  • Page 17: Air Filter

    If the machine is used in dusty conditions the air filter should be soaked in oil, see the section on “Oiling the air filter“. Oiling the air filter Always use HUSQVARNA filter oil, order no. 503 47 73-01. The filter oil con- tains a solvent to make it spread evenly through the filter.

  • Page 18: Maintenance Schedule

    Maintenance schedule Below follows some general maintenance instructions. If you need further information please contact your service workshop. Daily maintenance 1. Clean the outside of the machine. 2. Make sure the throttle trigger lock and the throttle function correctly from a safety point of view.
  • Page 19 Monthly maintenance 1. Clean the fuel tank. 2. Clean the carburettor and the area surrounding it. 3. Clean the fan wheel and the area around it. 4. Check the fuel filter and the fuel pipe, replace if necessary. 5. Check all cables and connections.

  • Page 20: Technical Data

    31806 and ISO 7916, m/s Idling, rear/front handles: Max. speed , rear/front handles: Blades Length, mm Blade speed at 9 000 rpm, Cut/min – English TECHNICAL DATA 325HS75 1,55/25,4 1,34/34 1,10/28 2 700 11 000 0,9 kW/ 9 000 rpm Walbro MB/CD...
  • Page 21 We, Husqvarna AB, S-561 82 Huskvarna, Sweden, tel: +46 36-146500, declare under sole responsibility that the hedge trimmers Husqvarna 325HS75 and 325HS99 from 1999’s serial numbers and onwards (the year is clearly stated in plain text on the type plate with subsequent serial number), are in conformity with the following standards or other normative documents following the provisions in the COUNCIL’S DIRECTIVES:...
  • Page 22 ´*3$^¶6/¨ 2000W03...
  • Page 23 We hope you find the links below useful. For further gardening information visit Blower Vacs Brush cutters Cultivators Cylinder lawn mowers Electric Fertiliser chainsaws spreaders Garden tractors Garden vacuums Hover mowers Husqvarna chainsaws Lawn scarifiers Lawn tractors Petrol hedge Ride on lawn cutters mowers Ryobi strimmers Scarifiers Gardening Tools Direct Brushcutters Chainsaws...

This manual is also suitable for:

325hs99

Table of Contents