FrontRow symbio 5201R Installer's Manual page 16

Install the Ceiling Sensor (cont.)
Mounting style #2: Suspended ceiling tile mount
1
2 x
5
14
1
1
1 / "
4
1
/ " holes / " hole
8 2
3
2
6
1. Locate the center of the ceiling tile and
mark holes using the mounting bracket as
a template.
2. Drill two
the tile.
3. Drill a /
1
2
the two mounting holes at 1
4. Insert the sensor cable through the
/ " hole.
1
2
5. Insert the two long machine screws
(2 x M3 x 25mm Phillips) through the
bracket and ceiling tile. Tighten the
screws into rear of ceiling sensor, as
shown above.
6. Connect the IR sensor cable to the ceil-
ing sensor pigtail above the ceiling tiles.
7. Route sensor cable above ceiling tiles
toward your receiver location, following
guidelines in chapter 4 and all applicable
building and electrical codes.
4
NOTE: Ensure cables are installed in
adherence to local and national electric
codes. Sensor cables should not rest on
the ceiling. Lift them off the ceiling and
use cable/zip ties to secure them loosely
to beams, anchor bolts, or other support
structures in the ceiling (do not attach
them to duct work, plumbing, or other
secondary work).
!
DO NOT ALTER THE IR SENSOR CABLE
Read the FrontRow Installer Guide thoroughly
before installing sensor cable. The cable has
been rigorously tested and qualified to work
with your FrontRow IR sensors.
• Do NOT shorten
• Do NOT alter or replace the RCA connectors
• Do NOT "splice" or split the cable
• Do NOT use a "Y" adaptor
• Do NOT use any other type of cable
Altering the cable in any way will result in
decreased performance of your system and will
void your Manufacturer's Limited Warranty.
/ " mounting holes through
1
8
" sensor cable hole in line with
IMPORTANT!
1 / " away.
4