Quick Start Procedure - Linear Technology DC2218A Demo Manual

QUICK START PROCEDURE

2. Remove power and the USB cable from the DC2218A
inputs.
3. Turn the PATTERN SELECT rotary switch S1 to position
7 for the GUI.
4. Connect 12V power to either the EMIVIN and GND
banana jacks or to the J7 2.1mm (inside diameter)
barrel jack.
5. Connect a USB cable between a PC and the USB con-
nector on the under-shield DC2026C (which arrives
included in the DC2218A package and pre-programmed
with DC2218A .ino code).
6. Launch the LT3965 GUI from QuikEval.
7. Click Connect to DC2218A to connect to the DC2218A
with the GUI.
DEMO MANUAL DC2218A
8. Observe the GUI program starts at ALL CHANNEL
MODE screen and the LEDs on the PCB are all off.
9. Start creating and testing I
CHANNEL MODE, SINGLE CHANNEL MODE, BROAD-
CAST, DIGITAL WRITE, READ REGISTERS, and LED
SETTINGS pages.
NOTE: An LT3965 GUI user guide is posted on the Linear
blog site. It contains the GUI commands and details.
Please contact Linear support for help with the GUI and
User Guide.
2
C commands with ALL
dc2218af
3