Table of Contents
Advertisement
Refilling the salt
When
Add salt and run the
"QuickPowerWash" programme with the
"Express" option without a load
in the display, wait until the end of the
programme and then refill the salt
reservoir.
Confirm with OK.
The salt refill indicator will go out.
Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the load items.
Each time you remove the salt
reservoir cap, you must run the
65 °C QuickPowerWash
programme with the Express
programme option selected without
any load items in the dishwasher.
This will dissolve and remove any
traces of salt from the wash cabinet.
Before using for the first time
After the salt reservoir has been filled,
the salt refill indicator may still appear in
the display if the salt concentration has
not yet reached the correct level. In this
appears
case, confirm the message again with
OK.
The salt refill indicator will be switched
off if you have programmed the
dishwasher for a water hardness below
0.9 mmol/l (5 °dH – German scale).
29
Advertisement
Table of Contents
