Turn On; Source Menu - Philips 6000 Series User Manual

[Pin]: select this option if your wireless
•
router supports WPS and PIN setup
method.The radio generates an 8-digit
code number that you can enter into the
router
• [Skip WPS]: select this option if your
wireless router does not support WPS.
You are prompted to enter the key for
yourWi-Fi network
As instructed on the display panel, press
WPS button or enter the pin on your
wireless router; or enter the key to
connect to your network (The options
displayed depend on the type of your
network and network protection used).
• When entering the key of the
network, to select a character; turn
SELECT knob, then press SELECT
knob to con rm.
• To cancel, turn SELECT knob to select
[CANCEL].
• To con rm your entry, turn SELECT knob
to select [OK].
To delete the entry, turn SELECT knob to
•
select [BKSP].
• To exit the process, press
If the network connection is
established, [Connected] is displayed.
When [Setup wizard completed] appears,
press OK to exit the setting.
Tip
• For some Wi-Fi routers, you may need to hold
the WPS button for Wi-Fi connection. See the
user manuals of the speci c routers for details.
• To run the setup wizard again, select [System
settings]>[Setup wizard] menu (see the Chapter
"Use system settings menu").

Turn on

•
Switch to standby mode
•
• If the system is idlefor15 minutes,the unit switches

Source menu

Press
.
Turn SELECT knob to select source
Press SELECT knob to con rm selection
Press .
The radio switches to the last
selected source.
Press again.
The display panel is dimmed.
The time and date (if set) are
displayed.
Note
to standby mode automatically.
to enter into source menu.
Internet
radio
EN