Table of Contents
Advertisement
Connect the power adapter to:
• the DC IN socket on the main unit.
• the wall outlet.
Set clock
1
In standby mode, press and hold CLOCK
SET on the remote control for two
seconds.
» [SET CLOCK] (set clock) scrolls on
the display, then the 12/24 hour format
blinks.
2
Press
/
repeatedly to select an hour
format.
3
Press CLOCK SET to confirm.
» The hour digits blink.
4
Repeat steps 2-3 to set the hour.
5
Repeat steps 2-3 to set the minute.
6
Repeat steps 2-3 to select whether to
synchronize time with RDS stations.
• [RDS TIME SYNC [Y]]: synchronize
time with RDS stations automatically.
• [RDS TIME SYNC [N]]: deactivate
time synchronization.
Note
•
The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
•
If the system is idle for 90 seconds, it exits clock setting
mode automatically.
8
EN
Turn on
Press .
» The unit switches to the last selected
source.
Note
•
To select a source, press SOURCE repeatedly or the
source selection buttons on the remote control.
Switch to standby mode
Press
again to switch the unit to standby
mode.
» The clock (if set) appears on the
display panel.
Store FM radio stations
automatically
When you connect AC power and no FM
stations are stored, the unit prompts you to
search and store all the available FM stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY, STOP
CANCEL] (to auto install, press
to cancel, press ) is displayed.
2
Press and hold
full scan.
» The unit automatically stores FM radio
stations with sufficient signal strength
and then broadcasts the first preset
station.
Tip
•
To exit storing mode, press
;
for 3 seconds to start
or
.
Advertisement
Table of Contents
