Turn on
Press .
» The unit switches to the last selected
source.
Note
•
To select a source, press SOURCE repeatedly or the
source selection buttons on the remote control.
Switch to standby mode
Press
again to switch the unit to standby
mode.
» The clock (if set) appears on the display
panel.
Set clock
1
In standby mode, press and hold CLOCK
SET on the remote control for two
seconds.
» [SET CLOCK] (set clock) scrolls on
the display.
2
Press CLOCK SET again.
» The 12 or 24 hour format blinks.
3
Press
/
repeatedly to select an hour
format.
4
Press CLOCK SET to confirm.
» The hour digits blink.
5
Repeat steps 3-4 to set the hour and
minute respectively.
Note
•
If the system is idle for 90 seconds, the unit exits clock
setting mode automatically.
10
EN
4 Play
Play disc
1
Press to open the disc compartment.
2
Insert a disc with the printed side facing up.
3
Press to close the disc compartment.
4
Press CD on the remote control to select
the disc source.
» [Reading] (reading) blinks for a
moment, then CD starts playing
automatically. If not, press
Play from USB
Note
•
Make sure that the USB device contains playable audio
content.
1
Insert the USB device into the
2
Press USB on the remote control to select
the USB source.
» Play starts automatically. If not, press
.
.
socket.