Half Active M, N And P Escutcheon Installation - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

M, N and P Escutcheon Trim
ML2000 Series Mortise Lock
Installation Instructions
3

Half Active M, N and P Escutcheon Installation

1. Install strike using shorter 3/4" strike
mounting screws. If strike box is
needed, insert between strike and door
frame. (Figure 17)
2. Insert mortise lock into door and hand
tighten longer 1" mounting screws.
(Figure 18)
NOTE:
Make sure lock is unlocked. If lock has a
toggle, push bottom of toggle inward to
unlock during installation.
3. Install inside adapter plate.
(Figure 19)
4. Mount escutcheon. (Figure 20)
5. Insert adjustment bolt and spindle. Tighten
bolt finger-tight and then loosen a few
turns. (Figure 21)
NOTE:
Use correct spindle orientation. (Figure 22)
Use Correct Spindle Orientation
Figure 22
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Corbin Russwin is a brand associated with ASSA ABLOY Access and Egress Hardware Group, Inc., an ASSA ABLOY Group company.
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without
the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
GOOD
BAD
Lever
Figure 18
5
Figure 17
Figure 19
Figure 20
Spindle
Adjustment
Bolt
Figure 21
FM483 11/18