Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual page 4

M, N and P Escutcheon Trim
ML2000 Series Mortise Lock
Installation Instructions
2 M, N and P Escutcheon Installation, (cont .)
6. Install inside lever or knob by inserting
dowel screw. (Figure 12)
NOTE:
Make sure adjustment bolt hole is aligned
with lever or knob hole. (Figure 13)
Adjustment bolt needs to
be threaded in farther.
Figure 13
7. Install cylinder. Secure with cylinder set
screw. (Figure 14)
NOTE:
• Pull key slightly out of cylinder to
help thread into lockbody.
• Cylinder must be oriented correctly.
(Figure 15)
8. Tighten lock mounting screws.
9. Install armored front. (Figure 16)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Corbin Russwin is a brand associated with ASSA ABLOY Access and Egress Hardware Group, Inc., an ASSA ABLOY Group company.
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without
the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Adjustment
Bolt
Lever
Misaligned.
Adjustment
Bolt
Lever
Misaligned.
Adjustment bolt needs to
be unthreaded.
Figure 14
4
Figure 12
Adjustment
Bolt
Lever
Adjustment bolt fully
aligned with lever hole and
ready to be secured with
set screw.
Key and cylinder
must be rotated
as shown.
®
ASSA ABLOY
Correct Incorrect
Figure 15
Figure 16
FM483 11/18