M Odulation Level/Dynamic Control - Kenwood KDC-CMP59FM Instruction Manual

M odulat ion level / D ynam ic cont rol
1
To set the control mode
Press the RDM button on the display unit for at least three
seconds.
The LEVEL indicator w ill light up and the currently set
modulation level w ill be displayed.
M odulation level
L E V E L
N OTE
• If this function is on, the functions other than pow er on / off,
reset, and changing the transmission frequency, cannot be
operated.
• This function is not available w hen the random play, repeat play,
or scan play function is on. Before using this function, cancel
the other functions. This function cannot be used w hile loading
a disc (w hile the play indicator is blinking).
2
To change the modulation level
Press either the 4 or ¢ button.
Each time the 4 or ¢ button is pressed, the modulation
level changes in the range from 1 to 4. As the number
increases, the modulation level increases.The initial setting is 2.
Num ber for prevention of
distortion setting
— 15 —
N OTE
Dynamic control
The unit comes w ith the prevention of distortion function to
reduce sound distortion.
If the sound is distorted severely, press the
display unit and then set the function to "2" (ON). If the
prevention of distortion function is set to "2" (ON), the sound
extension is reduced.
The initial setting is "1" (OFF).
2CA U TION
If a disc w ith a high recording level is used, the sound may
distort even if the prevention of distortion function is set to "2"
(ON). In this case, reduce the modulation level.
To cancel :
Press the RDM button on the display unit for at least three
seconds.
The LEVEL indicator w ill go off and the modulation level
change w ill take effect. The control mode is automatically
canceled if you do nothing for 15 seconds.
+
button on the