Table of Contents
Advertisement
Operation to reset
Power plug is loosely connected.
@ With the power plug connected
to the switched
AC outlet of an amplifier, the power of the
amplifier is turned off
power cord into the socket again.
@ Disc is ioaded upside down
Disc is loose.
@ Disc is dirty.
@ Disc is cracked,
untt.
@ Play mode is not entered
The connection cords are inserted loosely,
e Output level is attenuated too low
—|—.
+
e Insert disc properly.
condensation".
ePress the mim
key.
the remote contro! unit.
@Load the disc again with its label side up.
Replace the disc with a new one.
Connect all connection cords firmly.
@ Adjust the output level with OUTPUT key on
(24
@ Disc is too dirty.
@ Disc is cracked.
Oscillation is applied to this unit.
= ee
@ Replace the disc with a new one.
Play begins as soon as the unit is turned ON.
Remote control unit
Remote control operation is not possible.
already loaded
@ Batteries are exhausted,
@The remote control unitis too far away from the
main system, controlling angle is too large, or
there is an obstacte in between.
For the U.S.A.
STANDBY mode.
» Replace with new batteries.
controilable range.
disc from the player before setting the unit to
(2%
-
Operate
the remote control unit within the
-&
CAUTION:
those specified herein may result in hazardous rad
in compliance with Federal Regulations, following a
iation exposure.
re reproductions of
labels on, or inside the product relating to laser product safety.
' KENWOOD CORPORATION
' 2967-3, ISHIKAWA-CHO, HACHIOJI-SHI,
TOKYO, JAPAN
]
' KENWOOD CORP. CEATIFIES THIS EQUIPMENT
i{
CONFORMS TO DHHS REGULATIONS NO. 21
'\
CFR 1040.10, CHAPTER I, SUBCHAPTER J.
1
Location: Back Panel
Advertisement
Table of Contents
