Accessories; Installation Procedure - Kenwood KDC-CMP59FM Instruction Manual

A ccessories
External view
1
3
5
7
2CA U TION
The use of any accessories except for those provided might result
in damage to the unit. M ake sure only to use the accessories
shipped w ith the unit, as show n above.
2
4
6
8
9
Europe sales area only.
Inst allat ion Procedure
1. To prevent a short circuit, remove the key from the ignition and
disconnect the - battery.
2. M ake the proper input and output w ire connections for each unit.
3. Connect the w iring harness w ires in the follow ing order: ground,
battery, ignition.
4. Install the unit in your car.
5. Reconnect the - battery.
6. Press the reset button.
2WA RN IN G
When drilling a hole in the car chassis to install the unit, check
first that nothing is on the other side.
2CA U TION
• If the fuse blow s, first make sure the w ires aren't touching to
cause a short circuit, then replace the old fuse w ith one w ith the
same rating.
• Do not let unconnected w ires or terminals touch metal on the car
or anything else conducting electricity. To prevent a short circuit,
do not remove the caps on the ends of the unconnected w ires or
the terminals.
• After the unit is installed, check w hether the brake lamps,
blinkers, w ipers, etc. on the car are w orking properly.
• Insulate unconnected w ires w ith vinyl tape or other similar
material.
• Some disc changers need conversion cords for connection. See
the section on "Safety Precautions" for details.
Removing the transportation screw s
Remove all 3 transportation screw s for protecting the internal
mechanism before you start to install the unit.
Transportation
screws
N OTE
After removing the transport screw , retain it carefully and
attach it again before transporting the unit again.
— 16 —