Warning - Kenwood KDC-CMP59FM Instruction Manual

2Warning

2CA U TION
Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
In compliance w ith Federal Regulations,
follow ing are reproductions of labels on, or
inside the product relating to laser product
safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPM ENT
CONFORM S TO DHHS REGULATIONS N0.21 CFR
1040. 10, CHAPTER I, SUBCHAPTER J.
Location : Rear Panel
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications
to this equipment may cause harmful
interference unless the modifications are
expressly approved in the instruction manual.
The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
N OTE
This equipment has been tested and found to
comply w ith the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment may cause harmful interference
to radio communications, if it is not installed
and used in accordance w ith the instructions.
How ever, there is no guarantee that
interference w ill not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, w hich can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the follow ing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation betw een the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to w hich the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
N OTE
This Class B digital apparatus complies w ith
Canadian ICES-003.
— 3 —
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The label is attached to the chassis/case and
says that the component uses laser beams
that have been classified as Class 1. It means
that the unit is utilizing laser beams that are
of a w eaker class. There is no danger of
hazardous radiation outside the unit.