Before Applying Pow Er; Safety Precautions - Kenwood R-SE7 Instruction Manual

2

Before applying pow er

Units are designed for operation as follow s.
Europe and U.K. ................................................. AC 230 V only
U.S.A. and Canada ............................................ AC 120 V only
For the United Kingdom
Factory fitted moulded mains plug
1.The mains plug contains a fuse. For replacement, use
only a 13-Amp ASTA-approved (BS1362) fuse.
2.The fuse cover must be refitted w hen replacing the
fuse in the moulded plug.
3.Do not cut off the mains plug from this equipment. If
the plug fitted is not suitable for the pow er points in
your home or the cable is too short to reach a pow er
point, then obtain an appropriate safety approved ex-
tension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the
fuse and dispose of the plug immediately, to avoid a
possible shock hazard by inadvertent connection to
the mains supply.
IM PORTANT : The w ires in the mains lead are coloured
in accordance w ith the follow ing code:
Blue
Brow n : Live
Do not connect those leads to the earth terminal of a
three-pin plug.

Safety precautions

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE LIGHTNING FLASH WITH ARROWHEAD SYM BOL, WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED " DANGEROUS VOLTAGE"
WITHIN THE PRODUCT'S ENCLOSURE THAT M AY BE OF SUFFICIENT M AGNITUDE TO CONSTI-
TUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAM ATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER
TO THE PRESENCE OF IM PORTANT OPERATING AND M AINTENANCE (SERVICING) INSTRUCTIONS
IN THE LITERATURE ACCOM PANYING THE APPLIANCE.
Downloaded from: http://www.usersmanualguide.com/
: Neutral
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REM OVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL.
Caution : Read this page carefully to ensure safe operation.
The marking of products using lasers
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a w eaker class. There is no danger of
hazardous radiation outside the unit.
WARNING : TO PREVENT FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS AP-
PLIANCE TO RAIN OR M OISTURE.
Before applying pow er
(Except for some areas)
CLASS 1
LASER PRODUCT
R-SE7 / DP-SE7 / X-SE7 (En)