Kenwood R-SE7 Instruction Manual page 11

Caution for Connection
When connections are to be made, make sure that
the pow er plug is not plugged into a w all AC outlet.
Connect the equipment as show n in the figures.
Optical
fiber cable
(Supplied
w ith DM -SE7)
1.In case an associated system component is connected, also read the instruction manual of the component.
2.Insert the optical-fiber cable straight into the connector until it clicks.
Notes Notes 3.Be sure to attach the protection cap w hen the connector is not used.
4.Be careful not to bend, coil or bundle the optical fiber cable.
Downloaded from: http://www.usersmanualguide.com/
SYSTEM
CONTROL
DIGITAL
OUTPUT
OPTICAL
R L
LINE OUTPUT
Audio cord (x2)
(Supplied w ith DM -SE7)
DIGITAL IN
OPTICAL
REC
IN
1
PLAY
OUT
2
R L
SYSTEM
CONTROL
Caution regarding placement
To maintain proper ventilation, be sure to leave a
space around the unit (from the largest outer dimen-
sions including projections) equal to, or greater than,
show n below.
top panel : 50cm
side panel : 10cm
rear panel : 10cm
DM -SE7 (optional)
System connection
R-SE7 / DP-SE7 / X-SE7 (En)
DP-SE7
11