Operation Of Remote Control Unit - Kenwood R-SE7 Instruction Manual

Operation of remote control unit

Loading batteries
1 Remove the cover.
Operation
After plugging the pow er cord of this unit, press
the on/ standby key of the remote control unit to
turn the pow er of the system ON. When the
pow er is turned ON, press the key of the function
to be operated.
÷ When pressing more than one remote control keys
successively, press the keys securely by leaving an
interval of 1 second or more betw een keys.
1.The provided batteries are intended for use in operation checking, and their service life may be short.
2.When the remote controllable distance becomes short, replace both of the batteries w ith new ones.
Notes Notes
3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote
sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
Downloaded from: http://www.usersmanualguide.com/
2 Insert batteries.
÷ Insert tw o R6 (" AA" -size) batteries follow ing the polarity indications.
Operating range (approx.)
M odel: RC-SE9(E)
Infrared ray system
Operation of remote control unit
R-SE7 / DP-SE7 / X-SE7 (En)
3 Close the cover.
6 m
30° 30°
17
Rem ot e
sensor