Updating The Junos Software With The Cli; Adding Licenses With The Cli; Performing Basic Configuration With The Cli - Juniper J Series Quick Start Manual

2. Updating the JUNOS Software with the CLI

After starting up the Services Router, you might want to download the latest version
of the JUNOS software from the Juniper Networks Web site and load it onto the
router. You can use the CLI, but we recommend the J-Web interface for the
download. To update the JUNOS software with the CLI:
1. Go to http://www.juniper.net/support , and follow the links to download the
2. Download the JUNOS software to the router with the CLI or J-Web interface:
For complete instructions, see the J-series Services Router Administration Guide.

3. Adding Licenses with the CLI

If you purchased one or more licenses, you received an envelope with instructions
for obtaining license keys from the Web. To enable each license on the router, you
must add the license key. You can add one or more license keys from the CLI. To
add a license key and enable a license:
1. Follow the instructions in your license envelope to generate the license key
2. Copy the license key onto the router with the CLI:
For complete instructions, see the Getting Started Guide for your router.

4. Performing Basic Configuration with the CLI

In CLI configuration mode, you use the set command to enable features, and the
delete
active configuration on the router until you use the commit command. To configure
basic settings with the CLI:
1. From the CLI, enter configuration mode:
2. Set the IP addresses of the built-in Ethernet management ports 0 and 1 . For
JUNOS software for J-series routers to an FTP server.
root> request system software add validate unlink reboot source
from the Web site.
a. Type the following command, and press Enter:
root> request system license add terminal
b. When prompted, copy and paste the license key from the Web site at the
command line, separating multiple license keys with a blank line.
c. To exit license key entry, press Ctrl+D.
command to disable them. The commands you enter do not update the
root> configure
root#
example:
root# set interfaces fe-0/0/0 unit 0 family inet address 10.1.1.1/24
root# set interfaces fe-0/0/1 unit 0 family inet address 192.168.1.1/24
J-series Services Router Quick Start
Basic Connection and Configuration with the CLI
9