Cleaning & Maintenance - Sharp R-24AT Operation Manual

C
LEANING & MAINTENANCE
WARNING
• Do not allow grease or dirt to build up on the door
seals and adjacent parts as this may prevent the
door from closing correctly and may cause a leak-
age of microwaves. To clean use a mild detergent
solution on a soft damp cloth.
• DO NOT OPERATE the oven without the splash cover
in place.
• DO NOT REMOVE the splash cover UNLESS THE
POWER CORD IS REMOVED FROM THE OUTLET
because the rotary antenna, which is located on the
ceiling, operates for 1 minute after the door is opened
and injury could occur.
OVEN INTERIOR
Clean the microwave oven cavity, at the end of each day
with a damp soft cloth for hygienic reasons. For heavier
soil, use mild soap applied with a soft damp cloth wipe
clean ensuring all soap is removed. Make sure that the
soap or water does not penetrate through the small vents
in the walls which may cause damage to the oven. Take
SPLASH COVER
AT LEAST ONCE A WEEK, REMOVE THE SPLASH COVER AND WASH BOTH SIDES OF IT IN A MILD DETER-
GENT SOLUTION. A BUILD UP OF GREASE MAY OVERHEAT AND BEGIN TO SMOKE AND MAY BURN THE
SPLASH COVER. THE SPLASH COVER IS LOCATED IN THE TOP OF THE OVEN AND MAY EASILY BE RE-
MOVED. REMEMBER TO UNPLUG THE POWER CORD.
Removal:
1. Remove two thumb screws (A) as shown in Fig.1.
2. Remove the splash cover from the oven.
Door
OUTER CABINET
Wipe the outside cabinet with a mild detergent solution
on a soft cloth. The control panel must be wiped clean
whilst the door is open, therefore inactivating the oven.
Keep the air intake filter clean. Clean the air intake filter
once every two weeks.
Remove the air intake filter by pulling the two (2) clips on
the sides of the filter.
Wash the air intake filter in mild soapy water, rinse and dry
with a soft cloth.
After cleaning re-install the air intake filter.
Do not operate the oven without the air intake filter in place.
Downloaded from: http://www.usersmanualguide.com/
Fig. 1
Splash cover
(A)
• Keep the ceramic floor clean at all times. If you leave
grease or fat in the cavily, it may overheat, smoke or
even catch fire when next using the oven.
• Never use spray cleaners, oven pads or abrasive scour-
ers as these damage the surface of the oven.
• Do not remove the ceramic floor from the oven.
• Do not use commercial oven cleaners, abrasive or
harsh cleaners or scouring pads on any part of your
microwave oven.
• Do not sprinkle water onto the oven directly. It may
cause electric shock, leakage of electricity or damage
of the oven.
care not to let soapy water drip through the small holes in
the oven walls. Excess water spillage through these holes
will cause damage to the oven interior. It is important that
the door seals and sealing surfaces are kept clean at all
times, wipe regularly with a damp cloth.
The ceramic floor should be kept clean at all times. Minor
spills may be wiped with a damp cloth.
Reinstall:
1. Insert two projections of the cover (B) into the holes of
the oven cavity backplate as shown in Fig. 2.
2. Secure the cover to the oven ceiling with two thumb
screws (A) as shown in Fig. 1.
Holes
Air intake filter
Hole
Clip
28
Fig. 2
Splash cover
(B)
Clip
Air intake filter
Oven
Hole