Multiple Sequence Cooking; Repeat Cook; Express Defrost - Sharp R-24AT Operation Manual

MULTIPLE SEQUENCE COOKING

* Example: To cook for 5 minutes at 70% and then continue to cook for 20 minutes at 30%.
Step 1
Select
MANUAL /
manual
REPEAT
cooking.
Step 4
Enter desired
power level.
(70%)
Step 7
Press
POWER LEVEL
pad.
The display will
start to count
DISPLAY
down to zero.
Note: When you press START pad, the display will show the total cooking time.

REPEAT COOK

Your oven can remember the last manual programme.
* Example: To cook with the last programme, which was programmed for 2 minutes and 30 seconds at 50%.
Step 1
Select the
MANUAL /
repeat pad.
REPEAT
The display will
start to count
DISPLAY
down to zero.

EXPRESS DEFROST

You can defrost the food listed on the Express Defrost chart on page 19 easily by using the EXPRESS DEFROST pad.
The oven is pre-programmed with a time/power level cycle so that the food listed on the chart is defrosted evenly
and faster.
Select the food from the chart and then calculate total defrosting time from the chart.
Then enter the time you have calculated and start the oven.
* Example: To defrost 450g (1lb.) beef steak for 3 minutes in the R-22AT, (2 minutes 30 seconds in the R-24AT).
Step 1
Press
EXPRESS
EXPRESS
DEFROST
DEFROST
pad.
The display will
start to count
DISPLAY
down to zero.
Step 5
Press START pad
once to continue
defrosting.
TIPS: Allow foods to stand a few minutes after defrosting to equalize the temperature for better cooking results.
Check food after standing. If additional time is needed, continue to defrost with 20% power and additional time.
Foods that are the same thickness throughout defrost better. If foods have varied thickness, it may be
necessary to shield the thin edges with small flat pieces of aluminum foil to prevent overdefrosting.
For foods not listed in the chart refer to the manual defrost chart on pages 18-19.
Downloaded from: http://www.usersmanualguide.com/
Step 2
Enter desired
cooking time.
(5 min.)
Step 5
Press MANUAL/
7
REPEAT pad.
Step 8
Enter desired
power level.
POWER LEVEL
(30%)
POWER
ON
1
Check the last
DISPLAY
programme.
POWER
ON
1
Step 2
Enter desired
defrost time.
(3 min.)
DEF
POWER
ON
START
DISPLAY
Step 3
Press POWER LEVEL
5 0 0
pad.
Step 6
Enter desired
MANUAL /
cooking time for
REPEAT
the 2nd stage.
(20 min.)
3
POWER
1
3 0 0
Step 4
Halfway through defrost time
CHECK will flash and an audible
signal will sound.
Open the door. Turn food over and
shield any portions, close the door.
DEF
POWER
ON
11
POWER LEVEL
2 0
Step 9
Press START pad
once to start cooking.
Step 2
Press START
pad once to
start cooking.
Step 3
Press
START pad
START
once to start
defrosting.
ON
0 0
START
START
DEF CHECK POWER