Hobart Pipeliner Instructions Manual page 40

/
T-964C
PART THREE - MAINTENANCE INSTRUCTIONS
Air-flow blocked
Low air-flow
Leakage
BATTERY-CHARGING GENERATOR
AND VOLTAGE REGULATOR
No output
Low or unsteady output
Excessive output
Noisy generator
BATTERY
Discharged
Overheating
No output
STARTER
Slow speed
Inoperative
Unit improperly sited
Pan belt slipping
Plugged radiator
Radiator loose or defec­
tive
Water-pump seal worn
Cracked block or head
Short capacitors
Sticking or worn brushes
Open or shorted field or
armature
Defective regulator
Dirty commutator
High mica or commutator
worn
Defective regulator
Drive-belt slipping
Sticking or worn brushes
Defective regulator
Field grounded
Loose mounting
Worn bearings
Brushes improperly fitt.ed
Short-circuited wiring
Voltage regulator defec­
tive
Generator not charging
Voltage regulator defec­
tive
Low liquid level
Internal short
Loose connection
Worn brushes
Dirty commutator
Poor connection
Defective starter
Re-locate to clear air flow
Adjust belt tension
Blow with compressed air
from shutter side
Tighten or replace radiator
Replace exposed seal or en­
tire pump
Overhaul engine
Replace capacitors
Clean or replace brushes
Replace generator
Replace regulator
Clean
Replace generator
If cleaning points does not
correct, replace regulator
Adjust belt tension
Replace brushes
Replace regulator if clean­
ing points does not correct
Replace generator
Tighten bolts
Replace generator
Sand brushes to correct fit
Locate short and repair
Replace regulator
Replace regulator
Replace regulator
Add water
Replace battery
Check connector completely
Replace brushes
Clean up
Tighten all connections,
check starter-switch con­
tacts
Replace starter
28