Hobart Pipeliner Instructions Manual page 15

T-964C
PART TWO - OPERATING INSTRUCTIONS
PART TWO
OPERATING INSTRUCTIONS
SECTION 3 - RECEIPT OP EQUIPMENT
5. UNLOADING - When unloading from a railroad car, truck, or carrier of any kind,
remember, this welder is valuable equipment - USE CAUTION.
6. UNCRATING - As a general rule it is best to move the equipment to the location
where it is to be used before removing the crate. In removing the crate USE CARE
when bars, hammers, etc, are used so that the equipment inside is not damaged.
7. PACKING LIST - Check the equipment received against Hobart Brothers' invoice to
make sure the shipment is complete and the equipment is undamaged. If the equip­
ment has been damaged in transit, NOTIFY CARRIER (railroad, trucking company, etc.)
at once and file a claim for damages. If the shipment is incomplete or in error,
write or wire:
ORDER DEPARTMENT
Hobart Brothers Company
TROY, OHIO
Giving: 1. Order number.
2. Serial number of machine.
3. Pull description of parts in error.
SECTION 4 - INSTALLATION OP UNIT
8. INSTALLATION PROCEDURE
a. GENERAL INSTALLATION - Care should be taken to so locate the machine that
there will be as little opportunity as possible for excess moisture, dust, paint
spray, or corrosive fumes to be drawn into the unit. Moisture condenses on genera­
tor parts and electrical controls causing corrosion which can seriously affect
operation and efficiency of the unit. Dust and dirt cause needless extra wear on
all moving parts.
b. INDOOR INSTALLATION
(1) If the unit is to be operated inside a building, make certain there is
adequate ventilation to carry off escaping exhaust fumes and to provide an ample
supply of oxygen.
(2) Place the unit so that the exhaust fumes are carried out of the building
with the fewest number of bends in the exhaust line as possible.
■ (3) All gas exhaust connections must be gas-tight.
(4) Provide at least 2 ft. of space on all sides of the unit for ventilation
and servicing.
c. PORTABLE INSTALLATION - These above instructions also apply when the unit is
installed on a truck, trailer or other portable device.
6