Setting Water Hardness; Measuring Water Hardness; Water Softener Filter; Installing The Filter - DeLonghi ECAM35075 Instructions For Use Manual

22. "Descale complete": press OK;
23. "Fill tank": empty the container used to collect the rinse
water, remove the water tank and fill with fresh water up
to the MAX level, then put back in the appliance.
Descaling is complete.
Please note!
• If the descaling cycle is not completed correctly (e.g. no
electricity) we recommend repeating the cycle;
• After descaling, it is normal for the grounds container
(A11) to contain water;
• If the water tank has not been filled to the MAX level, at
the end of descaling, the appliance requests a third rinse to
guarantee that the descaler solution has been completely
eliminated from the machine's internal circuits.
• The appliance may request descaling cycles at very short
intervals. This is normal and due to the appliance's ad-
vanced control system.

16. SETTING WATER HARDNESS

The descale message is displayed after a period of time estab-
lished according to water hardness level.
The machine is set by default for a hardness level of 4. The ma-
chine can also be programmed according to the hardness of the
mains water in the various regions so that the machine needs to
be descaled less often.

16.1 Measuring water hardness

1. Remove the "TOTAL HARDNESS TEST" indicator paper (C1)
from its pack (attached to the English instructions);
2. Immerse the paper completely in a glass of water for one
second;
3. Remove the paper from the water and shake lightly. After
about a minute, 1, 2, 3, or 4 red squares form, depending
on the hardness of the water. Each square corresponds to
one level;
soft water (level 1)
slightly hard water (level 2)
hard water (level 3)
very hard water (level 4)
16.2 Setting water hardness
1. Press (B6) to enter the "Settings" menu;
2. Press the selection arrows (B2 and B4) until "General" is
displayed between the two lines. Press OK;
3. Press the selection arrows until "Water hardness" is dis-
played, then press OK;
4. The current selection appears on the display and the new
selection flashes. Press the selection arrows until the re-
quired new selection is displayed. Press OK.
The new level is saved and the appliance goes back to the "Gen-
eral" menu.
Press /ESC (B5) twice to go back to the main screen.

17. WATER SOFTENER FILTER

Certain models are fitted with a water softener filter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De'Longhi Customer Services.
To use the filter correctly, follow the instructions below.

17.1 Installing the filter

Please note
The filter lasts about two months if the appliance is
used normally. If the coffee machine is left unused with the filter
installed, it will last a maximum of three weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in fig. 37 until water comes out of the open-
ings at the side for more than a minute.;
0,5 L
4. Extract the tank (A17) from the appliance and fill with
water;
19
1. Remove the filter (C4)
from the packaging. The
date indicator disk varies
according to the filter
provided.
2. Turn the date indicator
36
disk (fig. 36) until the
next 2 months of use are
displayed.
37 38