Table of Contents
Advertisement
OPERATION
Read the entire important safety information section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Initial Battery Charging
Before the Security Light can operate properly, the batteries need to be fully charged. To
charge the batteries:
1.
Turn OFF the Power Switch.
2.
Allow 3 days of full sunlight to fully charge the batteries.
3.
After charging, turn the Power Switch Auto. The light will illuminate for a short time
when first switched on. This indicates that it is working properly.
WARNING:
The Unit will not function unless:
The Solar panel is first charged for 3 days of full sun with the sensor off.
Power Switch
The Power Switch, located under the Battery Housing of the Lamp has three settings:
OFF: Centre position.
ON: Towards the Lamp. The lamp stays on functioning as a normal light.
AUTO: Away from the Lamp. The light will turn on automatically when motion is detected by
the Motion Sensor Head.
Advertisement
Table of Contents
