Table of Contents
Advertisement
TROUBLESHOOTING
Problem
Light won't turn
on.
Light turns on
LUX control is set too close to.
during day.
Light flashes on
and off with
Low battery.
clicking sounds.
Light stays "on".
Light turns on
and off.
Follow all safety precautions whenever diagnosing or servicing Disconnect Battery Pack
and Charger power supply before service.
Possible Causes
1.
Power is not on.
2.
Cable connection is loose.
3.
LUX control is set too low.
4.
Motion sensor not detecting
movement.
5.
Battery pack not fully charged.
1.
Duration time setting too long.
2.
Frequent changes in heat
being detected.
3.
Power Switch set to on.
1.
Changes in heat are being
detected from a fixed heat
source or moving object.
2.
Sudden temperature changes
due to storms or high winds.
Likely Solutions
1.
Check that Power Switch
is set to on or auto.
2.
Plug-in firmly at the back
of Battery Housing.
3.
Turn LUX knob to turn
settings higher.
4.
Adjust angle and direction
of Motion Detector Head.
5.
Keep the solar panel
clean. Allow charging in
full sunlight for 3 days with
the Power Switch off.
Turn knob towards.
With Switch set to "off", allow
charging in full sunlight for 3 days
before further use.
1.
Turn TIME knob counter-
clockwise to reduce the
time the light stays on.
2.
Check sensing area for
possible heat sources such
as air vents, vehicles or
objects in wind. Reposition
the Motion Detector Head
if needed or turn SENS
Knob counter-clockwise to
lower sensitivity.
3.
Turn Power Switch to auto.
1.
Check sensing area for
possible heat sources such
as air vents, vehicles or
objects in wind. Reposition
the Motion Detector Head.
2.
Turn Power Switch "off"
until the storm passes.
Mount in a sheltered
location.
Advertisement
Table of Contents
