Table of Contents
Advertisement
SAFETY & WARNINGS
WARNING
Failure to follow these warnings and instructions may result in electric shock, fire and/or
serious injury. Save all warnings and instructions for future reference.
1.
Keep the installation area clean. Cluttered areas invite accidents.
2.
Observe installation area conditions. Keep work area well-lit during installation.
3.
Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for any broken or damaged parts and any
other conditions that may affect its operation. Replace or repair damaged or worn
parts immediately. Do not use the Security Light if any switch does not turn on and
off properly.
4.
Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
5.
Check hardware and assembled parts after assembling. All connections should be
tight and hardware tightened.
6.
Keep children away. Mount the Light, Solar Panel and Cord out of children's reach.
7.
Dress properly. Protective, electrically non-conductive clothes and non-skid
footwear are recommended when working with the Solar Powered Security Light.
Wear restrictive hair covering to contain long hair.
8.
Use eye protection. Wear ANSI-approved impact safety goggles when setting up
this product.
9.
Maintain products with care. Keep the Solar Powered Security Light clean for better
and safer performance. Inspect the Light periodically. If damaged, have it repaired
by a qualified technician.
10. Do not overreach. Keep proper footing and balance at all times. If a ladder is to be
used during installation, it should be supported by an assistant.
11.
Do not set up the Solar Powered Security Light if under the influence of alcohol or
drugs. Read warning labels on prescriptions to determine if your judgement or
reflexes are impaired while taking drugs. If there is any doubt, do not set up the
Light.
12. NiCd battery must be recycled or disposed of properly. Do not short, incinerate or
open the battery.
13. Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
14. The warnings, precautions and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product but must be supplied by the operator.
Advertisement
Table of Contents
