Siemens PROFIBUS PA SIPART PS2 Manual page 115

d nn.n x
U-->d x
NOZZL x
TESt x
LEAKG x
nn.n x
x
oMIN
_
nn.n x
FINSH x
Reports on leaving "configuration" operating mode:
Cn x
VER x
Error x
SLnn
x
MA ---- ---- x
CPU x
START x
HW / x
ERROR
NOINI x
nnn.n x
AUnn x
MAnn
SIPART PS2 PA Manual
A5E00127926-03
Meaning/Cause
Display the positioning time "Down"
Actuator stationary (initialization inter-
rupted with the "--" key during actua-
tion speed display)
Leakage test active initialization inter-
rupted with the "+" key during actua-
tion speed display)
Value and units of results of the leak-
age test
Initialization completed successfully,
with display of the actuator travel or
positioning angle as appropriate
Meaning/Cause
Software version
Monoticity transgression of
the free characteristic line
at support point "n"
x No communication in ma-
nual mode
Air discharge valve will be
opened
Message after applying
auxiliary electrical power
Fault in the hardware
x Positioner not initialized
x x Setting actual value [in %]
for initialized positioners.
Flashing decimal point in-
dicates communication
with a class 2 master
x Automatic mode (nn = set-
point)
x Manual mode (nn = setpo-
int)
Actions
Wait, or
S
To change the positioning time inter-
S
rupt initialization with the "--" key,
or
Activate the leakage test with the "+"
S
key
Positioning time can be adjusted by
S
varying the choke(s)
Use the "--" key to repeat the deter-
S
mination of the positioning speed
Continue using the "+" key
S
Wait 1 minute
S
Continue with the "+" key
S
Remove leakage if value is too high.
S
Continue with the "+" key
S
Press "operating mode" key briefly to
S
acknowledge or longer to quit confi-
guration mode
Actions
Wait
S
Correct value
S
Press operating mode
S
key to change to auto-
matic mode
Check station address
S
Start communication
S
Wait
S
Exchange electronics
S
Start initialization
S
Press operating mode
S
key to change to auto-
matic mode
Operation
113