Table of Contents
Advertisement
www.ti.com
1-2 (Debugger): Power supply from JTAG interface
2-3 (External): External power supply
External power connector
Jumper J1 to External
Jumpers JP5 to JP10
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Open to measure current
Jumpers JP11 and JP12
Open to disconnect LEDs D1 and D2
LEDs connected to P1.0, P1.1
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
Jumper J1
Connector J2
Jumper JP1
D1, D2
Figure B-37. MSP-TS430PT48 Target Socket Module, PCB
Copyright © 2020 Texas Instruments Incorporated
Connector JTAG
Connector BSL
For JTAG tool
For bootloader tool
Hardware
BSL Interface Switches
Select which BSL interface to
connect to connector BSL
I2C pullup enable switch
Switch on to connect
I2C pullup resistors
Orient pin 1 of MSP430 device
MSP430™ Hardware Tools
85
Advertisement
Table of Contents
